Bosch Professional GOP 18V-34 Original Instructions Manual page 20

20 | English
LED
2 × continuous green light
1 × continuous green light
1 × flashing green light
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50 °C. Do not leave the battery in your car in the summer, for
example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Assembly
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
The following table shows examples of accessories. You can find additional accessories in Bosch's extensive range of ac-
cessories.
Accessory
AIZ 10 AB
Starlock
10 × 20 mm bi-
metal plunge cut
saw blade for wood
and metal
AIZ 32 EPC
Starlock
32 × 50 mm HCS
plunge cut saw
blade for wood
AIZ 32 APB/
AIZ 32 APIB
Starlock
32 × 50 mm bi-
metal plunge cut
saw blade for wood
and metal
PAIZ 32 APB
StarlockPlus
32 × 60 mm bi-
metal plunge cut
saw blade for wood
and metal
1 609 92A 8RD | (07.08.2023)
changing tool, etc.). The battery should also be re-
Capacity
moved for transport and storage. There is risk of injury
20–40 %
from unintentionally pressing the on/off switch.
5–20 %
Changing the tool
0–5 %
Wear protective gloves when changing accessories.
u
There is a risk of injury when touching the accessories.
Selecting an accessory
Please observe the accessories intended for your power
tool.
Accessory
Material Application
Softwood, soft plastics, Smaller separation and plunge cuts; delicate adjustment
gypsum, thin-walled alu- work in wood;
minium and non-ferrous Example: Cutting recess for cable, plunge cuts in gypsum
metal profiles, thin metal boards, resawing recesses for locks and fittings
sheets, non-hardened
nails and bolts
Softwood Splinter-free separation and plunge saw cuts thanks to
round sawing edge (Curved-Tec); also for sawing close to
the edge, in corners and difficult-to-access areas;
Example: Plunge cut for the installation of a ventilation
grille or recess for plug sockets
Composite materials Tear-free flush cuts and plunge cuts in wood, soft non-fer-
made from wood and soft rous metals and plastic thanks to round sawing edge
non-ferrous metals, un- (Curved-Tec);
hardened nails and Example: Recess for plug sockets and pipes, flush cuts
screws, pipes made from through unhardened nails and screws
non-ferrous metal and
profiles with small dimen-
sions
Composite materials Quick and deep plunge cuts in wood, abrasive wooden ma-
made from wood and soft, terials and plastics, splinter-free work thanks to round cut-
non-ferrous metals, un- ting edge (Curved-Tec);
hardened nails and bolts, Example: Quick separation of non-ferrous pipes and pro-
pipes made from non-fer- files of smaller dimensions, easy cutting through non-
rous metal and profiles of hardened nails, bolts and steel profiles of smaller dimen-
smaller dimensions sions
GOP 18V‑34
Bosch Power Tools