Table of Contents
Advertisement
Preparation
To Insert Lithium Batteries
This unit uses two lithium batteries to keep data for editing,
To remove the lithium batteries
titles or infrared contro! signal of the remote control unit in
Press the side of the battery in the direction indicated for
memory.
installation.
Open the cover of the lithium battery
compartment (bottom).
Lithium battery life
:
Approximately 1 year in normal operation.
\
When the lithium batteries become weak, the GO mark will
light in the display window.
In this case, replace the
batteries with Sony CR2025 lithium batteries. Use of other
batteries may present a risk of fire or explosion.
Install the supplied two CR2025 lithium
batteries with correct polarity.
Note
Replace the batteries within approximately 20 seconds
to keep the data for editing, titles or infrared control signal of
the remote control unit in memory.
When the batteries are discharged completely, memorize
p
them again.
Notes on lithium battery
* Keep the lithium battery out of the reach of children.
<p
Should the battery be swallowed, immediately consult a
doctor.
ra
* Wipe the battery with a dry cloth to assure a good contact.
+ Be sure to observe the correct polarity when installing the
battery.
* Do not hold the battery with metallic tweezers, otherwise a
Close the cover,
short-circuit may occur.
* Do not break up the battery nor throw it into a fire, which
might cause it to explode. Carefully dispose of the used
Connect the AC power adaptor and turn on
batteries.
the POWER switch on the left side. Check
that the GO mark is not displayed.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Advertisement
Table of Contents
