Basic Operations - Clarion ARX7370R Owner's Manual

7. OPERATION
Basic Operations
Be sure to set the volume to the minimum
level before turning off the power to the unit.
Loud sounds when turning on the power may
impair your hearings or cause damage to the
unit.
Turning on the power
Note:
e Be sure to start the engine before using the unit to
prevent the battery from running down.
. Press POWER button [1].
The illumination and display on the unit light
up. The unit starts in the function mode it was
in when the power was turned off last.
Press and hold POWER button [1] for 1 sec-
ond or longer to turn off the power.
po —
&
Selecting a mode
1. Press FUNC button [1] to select a function
mode.
2. The function mode changes in the following
order:
Radio - Tape - CD changer ~ Radio ...
* If the CD changer is not connected, the CD
changer mode cannot be selected.
Adjusting the volume
Select up or down to increase or decrease using
a-selector [2].
* Selecting up or down and holding for 1 second or
longer on the a-selector [2] continuously increases
or decreases the volume respectively.
* The volume level (step 0 to 33) appears in the dis-
play.
10 ARX7370R/ARX7370RW
Note: Be sure to read this chapter referring to the front diagrams of
chapter "4. CONTROLS' on page 5 (unfold).
Adjusting audio mode (use o& -selector)
Press A-M bution [13] to select an item to be ad-
justed.
Each time you press the button, the item changes ~
in the following order:
Bass/Treble - Balance/Fader -» Mode display...
* The display returns to the previous mode 7 sec-
onds after the adjustment.
Adjusting the tone
Select "BA:TR" (bass/treble) in the display.
@BASS adjustment (step —6 to +6)
Select right or left to increase or decrease.
@TREBLE adjustment (step —6 to +6)
Select up or down to increase or decrease.
TOL
ary oe
LIN |
Note:
e When the expand DSP (Digital Sound Processor)
or EQ (Equalizer), sold separately, is connected
to the unit, the tone adjustment mode cannot be
selected. To adjust the tone, see the section
"DSP and Equalizer Operations".
Adjusting the balance (step L9 to R9)
1. Select "BA:FA" (balance/fader) adjustment in
the display.
2. Select right or left to balance the right or left
sound level.
Adjusting the fader (step F9 to R9)
1. Select "BA:FA" (balance/fader) adjustment.
2. Select up or down to balance the sound to-
ward the front or rear of the vehicle.
aa: oe
rm Ct \~ m
ny a te 4