Table of Contents
Advertisement
The system is switched on once.
▷
Departure time with weekday: time and day
of the week of the scheduled departure can
be set.
The departure time is preselected in two steps:
▷
Set departure times.
▷
Activate departure times.
The climate control function will start approxi‐
mately 10 minutes before the set departure time
and continue for approximately 5 more minutes
after the departure time.
A minimum of 10 minutes should pass between
setting/activating the departure time and the
planned departure time to allow a sufficient pe‐
riod of time for the climate control.
For reasons of safety, the system can only be
switched on once. The system will be available
again as soon as the drive-ready state is acti‐
vated and deactivated again.
Observe the information about the intended use
of the vehicle.
Additional information:
For Your Own Safety, refer to page 8.
Adjusting the departure time via
iDrive
1.
"CAR"
2.
"Settings"
3.
"Climate control"
4.
"Preconditioning/ventilation"
5.
"Departure plan"
6.
Select the desired departure time.
7.
Set the departure time.
8.
Select day of the week, if needed.
Adjusting the departure time via
BMW display key
1.
Switch on the display of the BMW display
key.
2.
"Preconditioning setting"
Online Edition for Part no. 01405A38D29 - VI/21
Climate control
3.
Tap on the icon.
4.
Select the desired departure time.
5.
Set the departure time.
6.
Select day of the week, if needed.
7.
"OK"
Activating the departure time via
iDrive
1.
"CAR"
2.
"Settings"
3.
"Climate control"
4.
"Preconditioning/ventilation"
5.
"Departure plan"
6.
Activate the desired departure time.
Activating the departure time via
BMW display key
1.
Switch on the display of the BMW display
key.
2.
"Preconditioning setting"
3.
Tap on the icon.
4.
Activating the desired departure time:
Tap on the icon.
Display
In the instrument cluster:
The engine runs for the purpose
of operating the pre-conditioning.
The vehicle is not ready to drive.
The icon on the automatic climate con‐
trol signals an activated departure time.
The icon flashes while Remote Engine Start
is running.
Confirmation signals from the
vehicle
The activation of the system is confirmed by
flashing twice.
CONTROLS
283
Advertisement
Table of Contents
