Table of Contents
Advertisement
CONTROLS
The system does not detect whether an obstacle
moves later on. For this reason, at standstill, the
markings are not shown anymore in the display
after a certain time. The area next to the vehicle
must be newly captured.
Door opening angle
Principle
If obstacle marking is activated, the Surround
View indicates fixed obstacles that obstruct the
opening angles of the doors.
The system does not provide a warning of ap‐
proaching road users.
Display
The maximum opening angle of the doors is dis‐
played in selector lever position P. As soon as
the vehicle begins moving, the opening angles
are replaced by parking aid lines.
Limits of the display
The vehicle's surroundings are displayed with
distorted image for technical reasons.
Even if the symbols for the door opening angles
do not cross other objects on the Control Dis‐
play, the following needs to be noted when park‐
ing next to other objects:
Because of the perspective, higher, protruding
objects may be closer than they appear on the
Control Display.
264
Driver assistance systems
Online Edition for Part no. 01405A38D29 - VI/21
Setting brightness and contrast
Brightness and contrast can be adjusted with
Surround View or Panorama View switched on.
1.
Move the Controller to the right, if needed.
2.
"Camera image"
3.
Select the desired setting.
Functional limitations
The system can be used only to a limited extent
in the following situations:
▷
In poor light.
▷
In case of soiled cameras.
▷
With a door open.
▷
With the trunk lid open.
▷
With exterior mirrors folded in.
Gray hatched areas with icon, for instance open
door, in the camera image mark areas that are
currently not displayed.
System limits
System limits of the sensors
Additional information:
▷
Cameras, refer to page 37.
Non-visible areas
Because of the camera angle, the areas under
the vehicle cannot be viewed by the cameras.
Detection of objects
Very low obstacles as well as high, protruding
objects such as ledges may not be detected by
the system.
Some assistance functions also consider data
from the PDC Park Distance Control.
Follow the notes in the PDC Park Distance Con‐
trol chapter.
The objects displayed on the Control Display
may be closer than they appear. Do not estimate
the distance from the objects on the display.
Advertisement
Table of Contents
