Table of Contents
Advertisement
▷
If selector lever position R is engaged when
the engine is running.
▷
Depending on the equipment version: while
approaching detected obstacles at a speed
slower than approx. 2.5 mph/4 km/h. The ac‐
tivation distance depends on the situation in
question.
You may switch automatic activation when ob‐
stacles are detected on and off.
1.
"CAR"
2.
"Settings"
3.
"Driver Assistance"
4.
"Parking and Maneuvering"
5.
If necessary, "Automatic PDC Activation"
6.
"Automatic PDC Activation"
Depending on equipment, an additional camera
view is also switched on.
Automatic deactivation during
forward travel
The system switches off when a certain driving
distance or speed is exceeded.
Switch the system back on, if needed.
Switching on/off manually
Press the park assistance button.
▷
On: the LED lights up.
▷
Off: the LED goes out.
The rearview camera image is displayed if the re‐
verse gear is engaged when pressing the park
assistance button.
Depending on the equipment version, the sys‐
tem cannot be switched off manually if the re‐
verse gear is engaged.
Driver assistance systems
Online Edition for Part no. 01405A38D29 - VI/21
Warning
Signal tones
General information
An intermittent tone indicates when the vehicle
is approaching an object. E.g., when an object is
detected at the rear left of the vehicle, a signal
tone sounds from the rear left speaker.
The shorter the distance to the object, the
shorter the intervals.
When the distance to a detected object is less
than approx. 8 in/20 cm, a continuous tone is
sounded.
When there are objects in front of and behind the
vehicle at the same time, with a distance smaller
than approx. 8 in/20 cm, an alternating constant
tone will sound.
The intermittent tone and constant tone are
switched off if the selector lever position P is en‐
gaged.
The intermittent tone is switched off after a short
time when the vehicle is stationary.
Volume
The PDC signal tone volume can be adjusted.
1.
"CAR"
2.
"Settings"
3.
"Driver Assistance"
4.
"Parking and Maneuvering"
5.
"Volume PDC signal"
6.
Set the desired value.
CONTROLS
247
Advertisement
Table of Contents
