IBM 5225 Operator's Manual page 50

4. Push the tension fingers to the rear of the printer. Be sure the first print line
is below the dark area on the tension fingers. If not, pull the tension fingers
toward you and turn the vertical adjustment control to lower the first print line
more. Then push the tension fingers to the rear and recheck. Repeat this
procedure until the first print line is below the dark area.
5. Turn the vertical adjustment control to raise the bottom of the first print line
qj)
up to the bottom of the dark area
~
on the tension fingers.
Note: The final forms movement should be upward. Downward movement
buckles the forms at the tension fingers.
x= position of the first print line
1 =
Qi__I()
Loading and Unloading Forms 3-15