INSTALLATION SAFETY PRECAUTIONS
!
●
Read this installation manual entirely before assembling this equipment.
●
Verify that there is adequate space surrounding this piece of equipment for safe access and operation. Installation
must meet ADA requirements for accessibility.
●
Install this piece of equipment on a solid level surface that does not deviate more than 1/8" over a 10' distance (or as
defi ned and required by local building and architectural codes.)
●
TRUE strongly recommends that all equipment be anchored to the fl oor to prevent movement and increase
stability.
○
Due to the wide variation of fl ooring on which the unit can be installed, contact a qualifi ed contractor to determine
an appropriate fastening system for your fl oor.
○
Use 3/8" diameter hardware (10 mm) to anchor the machine. Anchors should have a minimum pull out force of
220 lb (110 kg) for each position.
○
When attaching the machine to the fl oor, if there is a gap between the machine foot and the fl oor, do not use the
anchor to remove the gap as this can cause the machine frame to deform. Instead, place a shim between the
bottom of the foot and the fl oor, then tighten the anchor.
○
Anchoring holes are provided on the feet of the frame. All anchoring locations must be used when anchoring the
equipment to the fl oor.
●
DO NOT install any fi tness equipment near a pool, hot tub or other damp locations. Corrosion caused by installation in
these locations can lead to premature failure of components.
●
Be sure all hardware is tight before using this machine.
●
Some assembly materials may come preassembled in the carton. Refer to the Assembly Instructions for instructions
on disassembling assembly materials where appropriate before beginning assembly.
MAINTENANCE SAFETY PRECAUTIONS
!
●
Refer to the maintenance schedule table in this manual for when to perform maintenance.
●
Check the function of your machine DAILY by verifying the following:
○
If equipped with cables, inspect cables and end fi ttings for any signs of wear. Replace if worn, frayed, or damaged
with TRUE replacement components.
○
Verify that all adjustments are possible and carried out with ease. Make sure that each adjustment pin inserts
completely into each position without binding.
○
Verify that safety catches and stops are in proper working order and engaged.
○
Verify that the exercise is performed smoothly, free of noise, and/or binding.
○
If equipped with a weight stack, verify that the proper weight selector pin is in place.
●
Check the function of your machine WEEKLY by verifying the following:
○
Nuts, bolts, and fasteners—check tightness weekly. If any hardware has become loose, retighten and/or use
Loctite
brand Threadlocker 242. Be sure all hardware is tight before using the machine.
TM
○
Frames and Lifting Arms: Inspect weekly for integrity and function. Replace any component at fi rst signs of wear.
Use only TRUE supplied components.
●
Replace any warning label at the fi rst sign of wear. Labels and the facility safety sign may be obtained from TRUE.
8