True SPL1300 Owner's Manual page 27

Low back extension

Hide thumbs Also See for SPL1300:

Table of Contents

STEP 3—ATTACH WEIGHT STACK TO UPRIGHT ASSEMBLY CONTINUED

Insert the selector pin and route the upright cable down through the hole on the upright assembly. Using an open end

wrench, attach the cable bolt to the top weight assembly.

IMPORTANT! A minimum of 1/2" (12.7 mm) of the threaded portion of the cable bolt must be threaded into the top

weight assembly.

NOTE: Verify the selector pin slides in and out of each weight plate.

NOTE: One person should prop up the arms while another secures the upright cable to the top weight assembly.

g. Using an allen wrench, remove the 1 hex screw, 1 lock washer, and 1 ﬂ at washer from the top right side of the

Generation 1 top weight assembly. Using an allen wrench, remove the 1 hex screw, 1 lock washer, and 1 ﬂ at washer

from the top right attachment point of the Generation 2 top weight assembly.

Generation

Table of Contents

22-spl1300000