Table of Contents
Advertisement
1.
Press the Select button to enter the main
menu.
Press:
Display:
2.
Press the down arrow button to navigate to the
Genset System menu. See Figure 43.
Press:
Display:
3. Press the Select button to enter the genset system
menu.
Press:
Display:
4. Press the down arrow button, if necessary, to step to
the setting that you want to change.
5. When the setting is displayed (for example, System
Voltage), press the select button. The value will flash.
Press:
Display:
6. Press the up or down arrow buttons to increase or
decrease the setting.
Press:
Display:
Figure 43
Changing Genset System Settings
TP-7203
4/23
Changing System Settings on the RDC2 Controller
Overview - - >
1.2 h
Genset - - >
System
System Voltage:
240 V
System Voltage
240 V
System Voltage
220 V
7. When the desired setting is shown, press Select. The
value stops flashing.
Press:
Display:
8. Press the down arrow to step to the next setting.
Press:
Display:
9. To exit, press the down arrow button until return is
displayed.
Press:
Display:
10. Press the Select button to exit the menu.
Press:
Display:
11. Press Auto to signal the controller to exit the menus
and return to the generator set status display.
Press:
Display:
Note:
If no buttons are pushed, the controller returns to the status
display after 5 minutes.
System Voltage:
220 V
System Freq:
60 Hz
Return - - >
Overview - - >
1.2 h
Genset State
Standby
61
Hide quick links:
Advertisement
Table of Contents
