Cleaning & Replacing The Filter; Maintaining The Brush Roll - Bissell POWERGLIDE PET SLIM 3070 Series Quick Start Manual

Cleaning & Replacing the Filter
Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filter.
1. For best cleaning
performance, always clean
filter after each use. Turn
machine OFF. Remove dirt
tank by pressing tank release
button and sliding tank out.

Maintaining the Brush Roll

Go to support.BISSELL.com for tips on maintaining and replacing your vacuum.
1. Turn machine OFF and
press foot release button to
disconnect motorized cleaning
foot.
4. Reattach brush roll by
inserting into belt and pressing
into place.
Note: Any other maintenance or servicing not included in this manual should be performed by an
authorized service representative.
WARNING
operate vacuum without filter.
2. Twist top to remove filter
frame from separator. Remove
filter from filter frame housing.
Tap filter against the side of a
trash bin to remove dust and
debris.
2. Twist bottom screws with a
coin to remove bottom cover.
5. Attach and secure bottom
cover.
Before using your vacuum, make sure dirt tank is in locked position and filter is in place. DO NOT
3. Rinse under warm water and
squeeze to remove dirt. Lay out
for 24 hours until completely
dry. Reinstall filter into frame
with tag side touching frame.
3. Remove brush roll cover
and clear any debris from
brush roll.
BISSELL.com 5