Table of Contents
Advertisement
Cleaning & Replacing the Filter
Go to BISSELL.ca/support for tips on maintaining and replacing your vacuum filter.
1.
For best cleaning
2.
Twist top to remove filter
performance, always clean
frame from the separator.
your filter after each use. Turn
Remove the filter from the filter
machine OFF. Remove Dirt Tank
frame housing. Tap the filter
by pressing the Tank Release
against the side of a trash bin
Button and sliding the tank out.
to remove dust and debris.
Maintaining the Pet TurboEraser® Tool
Go to BISSELL.ca/support for additional accessories and replacement tools.
1.
2.
Twist gray collar counter-
Remove Brush Roll, Belt
clockwise, until slot appears,
and Paddle Wheel. Inspect
then separate faceplate.
for damages and replace if
necessary.
4.
To put faceplate back on,
align the tabs in the top of
the cover and place it down to
"click" into place.
WARNING
Before using your vacuum, make sure that the Dirt Tank is in locked position and that the fi lter is in
place. DO NOT operate your vacuum without the fi lter.
6 BISSELL.ca
3.
Rinse under warm water and
squeeze to remove dirt. Lay out
for 24 hours until completely
dry. Replace filter into the frame
with the tag side touching the
frame.
3.
To reassemble, align two clips
on each end of Paddle Wheel
with Belt on and pop back into
place. Place Brush Roll with
Belt back in. Faceplate will not
close properly if all parts are not
aligned correctly.
Advertisement
Table of Contents
