Cleaning & Replacing The Filter; Maintaining The Pet Turboeraser® Tool - Bissell CLEANVIEW 2831 Series User Manual

Cleaning & Replacing the Filter
Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filter.
For best cleaning performance, always clean your filter after each use.
1.
Turn machine OFF.
To clean the filter, remove Dirt
Tank by pressing the Tank
Release Button and sliding the
tank out.
Maintaining the Pet TurboEraser® Tool
Go to support.BISSELL.com for additional accessories and replacement tools.
1.
Twist gray collar counter-
clockwise, until slot appears,
then separate faceplate.
4.
To put faceplate back on,
align the tabs in the top of the
cover and place it down to
"click" into place.
6 BISSELL.com
2.
Twist top to remove filter
frame from the separator.
Remove the filter from the
filter frame housing. Tap the
filter against the side of a trash
bin to remove dust and debris.
2.
Remove Brush Roll, Belt
and Paddle Wheel. Inspect
for damages and replace if
necessary.
3.
To clean, rinse under warm
water and squeeze to remove
dirt. Lay out for 24 hours, until
completely dry. Make sure to
reinsert your filter into the
frame with the tag side down
(touching the frame) before
using your machine.
3.
To reassemble, align two
clips on each end of Paddle
Wheel with Belt on and
pop back into place. Place
Brush Roll with Belt back
in. Faceplate will not close
properly if all parts are not
aligned correctly.