Cleaning & Replacing The Filter; Maintaining The Pet Turboeraser® Tool - Bissell Powerglide Pet Slim 3070 Series Quick Start Manual

Cleaning & Replacing the Filter
Go to BISSELL.ca/support for tips on maintaining and replacing your vacuum filter.
For best cleaning performance, always clean your filter after each use.
1. 2.
Turn machine OFF. To clean Twist top to remove filter
filter, remove Dirt Tank by frame from the separator.
pressing the Tank Release Button Remove the filter from the filter
and sliding the tank out. frame housing. Tap the filter
against the side of a trash bin
to remove dust and debris.
Maintaining the Pet TurboEraser® Tool
Go to BISSELL.ca/support for additional accessories and replacement tools.
1. 2.
Twist gray collar counter- Remove Brush Roll, Belt
clockwise, until slot appears, and Paddle Wheel. Inspect
then separate faceplate. for damages and replace if
necessary.
4.
To put faceplate back on,
align the tabs in the top of
the cover and place it down to
"click" into place.
6 BISSELL.ca
3.
To clean, rinse under warm
water and squeeze to remove
dirt. Lay out for 24 hours until
completely dry. Make sure to
reinsert your filter into the
frame with the tag side down
(touching the frame) before
using your machine.
3.
To reassemble, align two clips
on each end of Paddle Wheel
with Belt on and pop back into
place. Place Brush Roll with
Belt back in. Faceplate will not
close properly if all parts are not
aligned correctly.