Emptying The Dirt Tank; Cleaning & Replacing The Filter - Bissell PET HAIR ERASER PRO 2831 Series Quick Start Manual

Emptying the Dirt Tank

More of a video person? Go to BISSELL.ca/support for additional how-to videos.
1. 2.
Turn OFF your machine. Grab the middle grip from the
Remove the Dirt Tank from the filter and pull up. This will activate
Hand Vacuum by pressing the Tank a wiping feature to remove debris
Release Button on the front of the from the mesh filter screen. Twisting
tank. the grip will remove the filter only.
4. Dump dirt from the tank into the 5. Slide the separator back into the
trash bin. tank, ensuring the notch is seated
into the tank correctly.
Cleaning & Replacing the Filter
Go to BISSELL.ca/support for tips on maintaining and replacing your vacuum filter.
For best cleaning performance, always clean your filter after each use.
1. 2.
Turn machine OFF. To clean Twist top to remove filter frame
filter, remove Dirt Tank by pressing from the separator. Remove the
the Tank Release Button and sliding filter from the filter frame housing.
the tank out. Tap the filter against the side of a
trash bin to remove dust and debris.
WARNING
» Do not use your vacuum until you are familiar with all instructions and operating procedures.
» Before using your vacuum, make sure that the Dirt Tank is in locked position and that the filter is in place. DO NOT operate your
vacuum without the filter.
3.
Fully remove the separator from
the tank and tap the mesh screen
on the side of the trash bin.
2
1
6. Put the whole tank into the
Hand Vacuum by guiding the
notched out area on the bottom of
the tank onto the hook on the Hand
Vacuum. Push into place.
3.
To clean, rinse under warm water
and squeeze to remove dirt. Lay out
for 24 hours until completely dry.
Make sure to reinsert your filter into
the frame with the tag side down
(touching the frame) before using
your machine.
BISSELL.ca 5