Deck Level Adjustment.31-33B; Front To Rear Level.32-33 & 33B - Snapper LT120G30DB Safety Instructions And Operator's Manual

MAINTENANCE INSTRUCTIONS
38"
DECK LEVEL ADJUSTMENT
Continued
Attach the rear hanger plates to the hole that
most closely aligns with the pin on the deck lift
bracket. Secure with washer and hair pin.
CAUTION
Make certain sector plates are mounted in the same
holes on each side for proper front to rear level.
Adjust the swivel on the front lift rod until it
lines up with the hole in the front lift bracket,
(make sure the lift rod is at the top of the slot in
the deck bracket) Secure with hair pin.
FRONT TO REAR LEVEL
Position the blades as shown in Fig. 70d.
Measure the distance from the left front blade
tip to the ground and from the right rear blade
tip to the ground. The front left blade tip should
be between 1/8" and 3/8" higher than the right
rear (factory setting). If it is between 1/8" and
3/8" you are finished with adjustment.
If it is not within specifications, adjust by raising
or lowering the front of the deck using the
the swivel on the front lift rod. Turning the swivel
clockwise will raise the front of the deck. Turning
the swivel counter-clockwise will lower the front of
the deck.
FRONT OF TRACTOR
FIGURE 70d
BLADES ORIENTATED FOR FRONT-TO-REAR
LEVEL CHECK
NOTE:
The deck should be set so that the rear of the deck is 1/4"
lower than the front. See Fig. 70e.
33" DECK SHOWN
FIGURE 70e