Adjustments before Output
Correcting Media Feeding
Procedure
1.
Click [Test Print].
A test pattern is printed.
2.
Follow the on-screen instructions and enter the value for [New Value].
The current correction value (A) is that of the figure indicated by "
the gap (B) and overlap (C) between the upper/lower squares smallest. In the case of the following
figure, select "−1.05%." When you cannot choose between two sequential numbers, specify a value
that is between them.
3.
Click [Apply].
The value in [Present Value] changes to the entered value.
4.
Click [Close].
5.
Click [Skip] on the subsequent adjustment screens.
[Cut adjustment], [Print and Cut adjustment], and [Crop cut adjustment] are not necessary with
this machine, so do not perform these adjustments here.
24
Initial Printer Settings
." Select the value to make