Casio SF-4300B Owner's Manual page 38

72
PART 6 Data Communications
3. Press 3 to select SET UP PAR.
#KSET UP PAR, sack
PARITY E O R
BIT LENGTH fi 8
BPS 4900 RBM
set.
The PARITY parameter is flashing because it is sefected.
dispiay.
currently selected parameter.
4,
5.
6.
About communications parameters...
Parity'
Parity is used for error detection during data exchanges. You can set the
SF Unit parity as even (E), odd (0), or none {N).
Bit Length
The bit length parameter states how many bits are to be used for each
character. You can set the SF Unit bit length as 7 bits or 8 bits.
BPS
The letters "BPS" stand for "bits per second," and this setting represents
the speed at which data is sent. The SF Unit lets you set a speed of either
4800 or 9600.
em
Setting Up for Data Communications eels
To set up the SF Unit to receive data
1, While an initial screen is displayed, press FUNC twice to display the second
function menu.
Youcan perform the above operation while the intial screen of the Telephone
Directory, Memo Mode, Schedule Keeper, Calendar, Reminder is displayed.
If you want the received data to be stored in the secret area, you should
also enter the secret area at this point. If you are in the open area on the
receiving unit, received data is stored into the open area.
Press 4 to select DATA COMM.
Press 2 to select RECEIVE.
Coreg RECEIVE OK
ATA +0 stop
ae PRESS<ESC)
This message indicates that the receive unit is standing by for data. Perform
the required procedures to start sending data from another SF Unit (see
owner's manual for details) or a personal computer (see the Interface Unit
manual for details).
To abort the receive operation at any time, press ESC.
This procedure is the same regardless of whether the data is received from
another SF Unit or from a personal computer.
The display changes to the following once the SF Unit starts receiving data.
RECEIVING
foe TENS
Receive data
item count
TO_STOP
Be) PRESSCESC)
The number of data items received is counted on the display.
If an error occurs during the receive operation, the message "TRANSMIT
ERROR!" appears on the display. Press ESC to clear the error message.
Received data is added to the data already stored in memary. If the memory
becomes full during the receive operation, the message "MEMORY FULL!"
appears and data transfer stops. Press ESC to clear the error message.