Casio SF-4300B Owner's Manual page 37

eo
Setting Up for Data Communications 2274
Data Communications
Data communications capabilities let you transfer data between two CASIO SF
Units, or between the SF Unit and a personal computer. You can perform such
operations in the Telephone Directory, Memo, Schedule Keeper, Calendar, or
Reminder mode.
Setting Up for Data Communications
The following describes what you should do to set up for data communications
between two SF Units or between the SF-4300B and a personal computer.
To connect the SF-4300B to another SF Unit
1. Make sure that the power of both units is switched off.
2. Remove the covers from the data communications jacks on the two SF Units.
3. Connect the two units using the SB-62 cable.
Important!
* Youcannot perform data communications with the CASIO SF-A Series of SF
'Units (SF-A10, ete.).
* Be sure to replace the connector covers on the SF Units when you are not
performing data communications.
Note that the optionally available FA-120 V3.50d Interface Unit is for data
communications between the SF-4300B and a personal computer. Though the
FA-100 and FA-150 Interface Units can also be used for data communications,
the software that comes with these interface units is unable to transfer Reminder
data.
To connect the SF Unit with a personal computer
1. First, ensure that the power of the SF Unit and the personal computer is
switched OFF.
2. Connect the personal computer to the FA-120 Interface Unit.
3. Remove the connector cover from the connector terminal of the SF Unit.
¢ Be careful not to lose the connecter cover. It should be replaced in the
connector terminal whenever the cabte is disconnected.
Connect the SF Unit to the FA-120 Interface Unit.
Switch the power of the personal computer ON, followed by the SF Unit.
« When data transfer operations are complete, switch power off in the se-
quence; SF Unit and then personal computer.
Next, disconnect the units. oi.
* For details on computer hardware requirements, see the communica-
tions software manual.
as
To set the SF Unit hardware parameters
1, Press FUNC twice to display the second function menu.
* You can perform the above operation in the Telephone Directory, Memo
Mode, Schedule Keeper, Calendar or Reminder.
2. Press 4 to select DATA COMM.