Engine Screen; Power Screen - Generac Power Systems Power Zone 410 Technical Manual

Engine Screen

The pages within the Engine Screen contain information
for viewing only. Use the navigation arrows (
navigate between the screens.
See 2-14. Page 1 displays the generator RPM,
Figure
coolant level, coolant temperature, and unit run time.
Engine
Generator RPM
Coolant Level
Coolant Temp.
Run Hours
Figure 2-14. Engine Screen (Page 1)
See Figure 2-15. Page 2 displays the engine oil tem-
perature, oil pressure, oil level ("N/A" is displayed instead
of "xxx%" when oil sensor is not detected), and fuel level
("Fuel Level" is displayed for diesel units, "Gas Pressure"
is displayed for propane and natural gas units).
Engine
Oil Temp.
Oil Pressure
Oil Level
Fuel Level
Figure 2-15. Engine Screen (Page 2)
See Figure 2-16. Page 3 displays the battery volts, inter-
nal battery charge amps, external battery charger status
(OFF = not connected, ON = connected), and battery
condition for the battery charger.
Technical Manual Power Zone 410 Controller
) to
xxx
xxx
xxxF
xxx:xxh:m
012988
xxxF
xxxkPa
xxx%
xxx%
012989
Engine
Battery Volts
Charge Amps
Ext. Charger
Battery Condition:
Figure 2-16. Engine Screen (Page 3)

Power Screen

See Figure 2-17. Page 1 displays the measured phase-
to-neutral voltages and calculated average phase-to-
phase voltage.
Generator Voltages (V)
Avg Gen Volts
AN
BN
CN
Figure 2-17. Power Screen (Page 1)
See 2-18. Page 2 displays average generator
Figure
current in Amps.
Generator Current (A)
Avg Gen Amps
A
B
C
Figure 2-18. Power Screen (Page 2)
General Information
xxxV
xxxA
OFF
Good
012990
xxx
xxx
xxx
xxx
012991
xxx
xxx
xxx
xxx
012992
11