Table of Contents
Advertisement
| CA-MX55MBK
1. Fold out the loop from the antenna base.
2. Connect one antenna wire to one of the AM LOOP terminals.
4. Adjust the loop antenna as needed to get the best reception.
AM Outdoor Antenna
Ifyour AM broadcastreception is unsatisfactory, youshould connect an AM
outdoor antenna in addition to the loop antenna.
Important! The AM loop antenna must be installed to receive AM broad-
antenna.
Re
. Loosen the screws holding the bracket.
. Loosen the cap of the 300/75-ohm terminal.
vi hON
=
75-Ohm antenna
with coaxial cable
center conductor
lan
shield braid
FM 300-Ohm Antenna Cable
. Loosen the cap on the 300/75-ohm terminal.
. Loosen the cap on the 300-ohm terminal.
. Tighten the caps on both terminals.
Note: Whether you use the 75-ohm or 300-ohm cable, make sure the
antenna conductors do not touch any other terminals on the rear panel.
This could cause poor reception.
> Qn
—
Note:
7
(No. 20342) 9
Advertisement
Table of Contents
