Setting On/Off For Warning And Qc History; Using Quick Image Checker Function - Eizo RadiForce RX440 Instructions For Use Manual

4-4. Setting On/Off for Warning and QC History

The warning and QC history displays for the failure of the Grayscale Check result can be set to on/off.
Procedure
1. Select "RadiCS SelfQC" from the Adjustment menu, and press
2. Select "Settings" from "RadiCS SelfQC", and press
3. Select "Warning" or "QC History" with
4. Select "On" or "Off" with
5. Press to exit.

4-5. Using Quick Image Checker function

A test pattern is displayed to enable a simplified check of the monitor display. (Quick Image Checker function)
Attention
• The Quick Image Checker function is not available under the following conditions.
- RadiCS/RadiCS LE is running (exit RadiCS/RadiCS LE if it is running).
- Adjustment menu is displayed.
- "PinP" is selected from "Optional Settings" – "Display Setup".
- Other than the DICOM/Custom/CAL1/CAL2/CAL3 mode is used.
• The Quick Image Checker function requires several minutes to prepare the patterns immediately after the monitor power is
turned on. Please wait for a while.
Note
• The AAPM test pattern is saved on the monitor by default.
• Only one pattern can be saved on the monitor.
• To change the pattern image, use RadiCS/RadiCS LE. For details, refer to RadiCS/RadiCS LE User's Manual.
Procedure
1. Hold down for two seconds or more.
2. The pattern image is displayed.
or .
or .
.
.
Chapter4ControllingMonitorQuality
35