Installation Of The Outdoor Unit - Toshiba MMY-MAP0804HT8-E Installation Manual

13-EN
SMMS-i
Weight centre and weight
◆ Weight centre of an outdoor unit
(A)
Anchor bolt position
700
X
No. Model type X (mm)
MAP080
(A) MAP100 500
MAP120
MAP140
(B) 605
MAP160
Installation Manual
(B)
Anchor bolt position
920
X
Weight (kg)
Y (mm) Z (mm)
Heat pump model Cooling only model
390 645 242
350 700 330
– 7 –
SMMS-i
6

INSTALLATION OF THE OUTDOOR UNIT

WARNING
• Be sure to install the outdoor unit in a place able to bear its weight.
If strength is insufficient, the unit may fall down resulting in human injury.
• Perform specified installation work to protect against strong wind and earthquakes.
If the outdoor unit is imperfectly installed, an accident by falling or dropping may be caused.
CAUTION
• Drain water is discharged from the outdoor unit. (Especially while heating)
Install the outdoor unit in a place with good drainage.
• For installation, be careful of the strength and level of the foundation so that abnormal sounds (vibration or noise)
are not generated.
REQUIREMENT
Installation in a snowfall area
1. Install the outdoor unit on a higher foundation than the snowfall or set up a stand to install the unit so that snowfall
will not affect the unit.
• Set up a stand higher than the snowfall.
• Apply an angled structure to the stand so that drainage will not be prevented. (Avoid using a stand with a flat
surface.)
2. Mount a snowfall-hood onto the air inlet and the air outlet.
• Leave enough space for the snowfall-hood so that it will not be an obstacle for the air inlet and the air outlet.
1. To install multiple outdoor units, arrange them with 20mm or more spaces in between.
Fix each outdoor unit with M12 anchor bolts at 4 positions. 20mm projection is appropriate for an anchor bolt.
241
330
Snowfall-hood for air
outlet (locally procured)
Snowfall-hood for air
outlet
(4 faces)
(locally procured)
Stand
(locally procured)
20mm or more
20mm or more
M12 anchor bolt
4 positions/unit
14-EN
Installation Manual