Table of Contents
Advertisement
Operating Source Components
OMAR
I ft Ikti7
Wow
WS bt eT
Ii/Remote /IiI
Control System
Remote Control
Automatic Source
Selection
Synchronized Recording
Automatic Power ON/OFF
Page 24
COMPU LINK Remote Control System
The COMPU LINK remote control system lets you operate the receiver and JVC components
from the remote supplied with this receiver. Control signals for JVC audio components are
preset in the receiver's remote control.
Connecting the COMPU LINK-3 SYNCHRO jacks on the back of the receiver will allow you
to use the four functions listed in the left column.
You can control all components via the REMOTE SENSOR on the receiver using the receiver's
remote control. For details, see page 25.
IMPORTANT! Point the remote control directly at the REMOTE SENSOR on the receiver.
When you press play on a component or the remote, the component begins playing immedi-
ately. On the other hand, ifyou select anew source on the receiver or the remote, the component
begins playing immediately, but the previously selected source continues playing without
sound for a few seconds.
Synchronized recording means the tape deck starts recording as soon as a CD or record begins
playing. To use synchronized recording, follow these steps:
Step 1
Puta
tape in the deck, and a disc in the CD player or on the turntable.
Step 2
Press the REC and PAUSE button on the tape deck at the same time. This puts the
tape deck in the REC/PAUSE state.
IMPORTANT!
If you do not press the REC button and PAUSE button together, the
gmchicnized recortling feature will not operate.
Step 3
Press the PLAY button on the CD player or turntable.
As soon as the disc starts playing, the tape deck starts recording. When the disc ends,
the tape deck switches back to the REC/PAUSE mode, and stops 4 seconds later.
NOTES:
¢
During synchronized recording, the CD or PHONO button is activated. Other
SOURCE buttons are disabled to prevent recording failure.
¢
Ifyour CD player is operated in the PROGRAM mode, a 4-second mute is recorded
between tracks to enable the music scan feature of your tape deck to work.
¢
If the power of any component is shut off during synchronized recording, the system
will not operate properly. In this case, you must start again with step 1.
The CD player and cassette deck turn on and off along with the receiver. When you turn on the
receiver (using either the remote or the receiver's POWER switch), the CD player or cassette
deck will turn on automatically, depending which component was previously selected.
NOTE: This function has been added to COMPU LINK-3 (Enhanced COMPU LINK), an
upgraded version of COMPU LINK-1. Refer to your JVC component manual for details.
Advertisement
Table of Contents
