Picture Tube Removal --S:serercrreceerssesseveeeesscesseeenens - Sony TRINITRON KV-13M10 Service Manual

KV-13M10/MT1300/
RM-Y116 RM-Y123
KV-14R10/1460R
RM-Y116_RM-Y123
2-4. PICTURE TUBE REMOVAL
@ C board
® Deflection yoke
@ Speaker
© Four screws
(Tapping screw 5)
- REMOVAL OF ANODE-CAP
Ze
ushion
NOTE : Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT chield or carbon
painted on the CRT, after removing the anode.
- REMOVING PROCEDURES
|
@ Turn up one side of the rubber cap in the @) Using a thumb pull up the rubber cap
direction indicated by the arrow @. firmly in the direction indicated by the
arrow (®).
» HOW TO HANDLE AN ANODE-CAP
@ Don't hurt the surface of anode-caps with
sharp shaped material!
@ Don't press the rubber hardly not to hurt
inside of anode-caps!
A material fitting called as shatter-hook
terminal is built in the rubber.
@ Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or
hurt the rubber.
Anode button
@ When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning up
the rubber cap and pulling up it in the
direction of the arrow ©.