Sony TRINITRON KV-13M10 Service Manual page 22

KV-13M10/MT1300/
RM-Y116 0 RM-Y123
KV-14R10/1460R
RM-Y116 _RM-Y123
1. Input a color-bar signal. 1. Input a color-bar signal.
2. Set to Service adjustment Mode. 2. Set to service adjustment Mode.
3. Set the conditions as follows. 3. Select DISP with[i]and [4].
PICTURE esse nia 4. Adjust with [3]and|6]for the bar center.
5. Write the memory by pressing [MUTING]then
COLOR Sey MIN
BRIGHT vs MIN ;
6. Check if the text is displayed on the screen.
ROFFO
vee ON (1)
SERVICE AFC
0
G OFF elk isreie oreo. OFF (0)
B OFF whe eeeees OFF (0)
SUB BRIGHT ADJUSTMENT (SBRT
1. Input a cross-hatch signal.
LG : iH to CN703 Pin) (R 2. Set to service adjustment mode.
eu mA o a oe ; ss 3. Set the PICTURE and BRIGHT to minimum.
) 0 .
a iin en 4, Select SBRT with|l|and [4].
5. Select SPIX with[1| and|4]. ; : . . why
. : 5. Adjust with [3]and [6] for obtain a faintly visible cross-
6. Adjust with 3]and(6|for the 1.940.05 Vp-p. hatch
atch.
6. Write into the memory by pressing |MUTING| then
White ENTER] .
1.90.05 Vp-p
SUB HUE, SUB COLOR ADJUSTMENT (SHUE, SCOL
. Input a color-bar signal.
. Set to service adjustment Mode.
. Connect an oscilloscope to CN703 Pin@ (B OUT) of
C board.
4, Select SHUE and SCOL with[t]and/4}.
. Adjust with 3|and|6|for the VI=V4 (SCOR) and V2
on =
7. Write the memory by pressing|MUTING}then
ENTER| .
8. Return the following back to normal after
Or
=V3 (SHUE).
adjustment.
Vi ve va v4
PICTURE) -:°+++:: MAX
BRIGHT
oo vvrreees
CENTER
COLOR
ocrrtseess
CENTER
: oe
eed
[
6. Write into the memory by pressing |MUTING
BORE
- issn
ON
then|ENTER| .