General; Setting Cable Tv On Or Offssssssseeesetteesertettetteeeeenseneeeane; Ete Eee Nee Ee Teereceeeesenaesescesseseeeeeees - Sony TRINITRON KV-13M10 Service Manual

Hide thumbs Also See for TRINITRON KV-13M10:
Table of Contents

Advertisement

SECTION 1
GENERAL
The operating instructions mentioned here are partial abstracts from
the
Operating
Instruction
Manual.
The
page
numbers
of
the
Connections
Connecting to a VCR
To connect the VCR to the TV, first check the model number of the TV
and select the appropriate connection diagram below. For details on
connection, see the instruction manual of the VCR. Before making the
connection, disconnect the AC power cords of equipment being used.
@ For KV-13M10/14R10
(Rear of TV)
Antenna cable
VHF/UHF input
VIDEO (yellow)
VHF/UHF output
Video and audio outputs
AUDIO (black)
oe ee
To watch video tapes
Press the TV/VIDEO button until "VIDEO" appears on the screen.
M For KV-MT1300/1460R
VHF/UHF input
VHF/UHF output
To watch video tapes
1 On the TV: Preset channel 3 or 4, whichever 1s not used in your area, following the
instructions for adding channels in "Presetting channels" (page 13).
2 On the VCR: Set the channel to the same channel as chosen above. Then begin
viewing the video tape.
8 | RE
Operating Instruction Manual remein as in the manual.
Setting cable TV on or off
If the TV is connected to a cable TV system, then the factory setting
CABLE ON is correct. If the TV is not connected, set CABLE to OFF.
Note
If more than 90 seconds elapse after you press a button, the menu disappears
automatically.
1° Press MENU.
The main menu appears.
MENU
>» VIDEO
SET UP
MTS: MAIN
CC/TEXT OFF
Use
¢ TA
&x! 11a)
2
Press A+ or V—on the remote commander to move the cursor (>) on
the screen to SET UP. To select that function, press RETURN.
The SET UP menu appears.
(x) R)
RETURN
'
CH ERASE/ADD
iy) Yr)
CH GUIDE
(
> MENU
Use (EIR)
Exit fey
Note
If CABLE appears in black, the TV 1s set to video input and CABLE cannot
be selected. Press TV/VIDEO so that a channel number appears.
Set CABLE to ON or OFF.
(3) If the cursor is not beside CABLE, press A+ or V— to move the
cursor and press RETURN.
,
R)
RETURN
A teal
hy
i
esac

Advertisement

Table of Contents
loading

Table of Contents