Precautions - Aiwa XR-DV525 Operating Instructions Manual

WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION ATTENTION
RISK OF ELECTRIC SHOCK | RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN NE PAS QUVRIR
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
This compact disc player is classified as a CLASS 1 LASER
product.
The CLASS 1 LASER PRODUCT label is located on the exterior.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1. LASER APPARAT
CAUTION!
Visible and invisible laser radiation when open
and inter locks defeated. Avoid exposure to beam.
WARNING
This appliance is supplied with a fitted three pin mains plug. A5
amp fuse is fitted in the plug.
Should the fuse need to be replaced, use a 5 amp fuse approved
by ASTA or BSI to BS1362. When replacing the fuse, you must
ensure that any removable fuse covers are correctly refitted.
If you should lose the fuse cover, please contact your nearest
AIWA dealer.
DO NOT CUT OFF THE PLUG FROM THIS APPLIANCE. If the
plug fitted is not suitable for the power points in your home, or
the cable is too short to reach a power point, obtain an appropriate
safety approved extension lead or adaptor. If in any doubt please
consult a qualified electrician.
If the plug is cut off, remove the fuse and dispose of the plug
immediately. THERE IS A DANGER OF SEVERE ELECTRICAL
SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13
AMP SOCKET.
If a new plug is to be fitted please ensure it contains a 5 amp
fuse, otherwise the circuit should be protected by a 5 amp fuse
at the distribution board.
2
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
BLUE — NEUTRAL
BROWN — LIVE
As the colours of the wires in the mains lead of this appliance
may not correspond with the colour markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the
terminal which is marked by the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the
terminal which is marked by the letter L or coloured RED.
DO NOT connect either the BLUE or BROWN wires in the mains
lead to the earth terminal (marked with the letter E or by the
earth symbol + or coloured GREEN or GREEN/YELLOW) of a
three pin plug.
PRECAUTIONS
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well
as the safety suggestions below.
installation
1 Water and moisture — Do not use this unit near water, such
as near a bath, sink, swimming pool, or the like.
2 Heat — Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C
(41°F) or greater than 35°C (95°F).
3 Mounting surface — Place the unit on a flat, even surface.
4 Ventilation — The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the
unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
5 Objects and liquid entry — Take care that objects or liquids
do not get inside the unit through the ventilation openings.
6 Carts and stands — When placed or mounted on a stand or
cart, the unit should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause
the unit or cart to overturn or fall.
7 Condensation — Moisture may form on the disc pickup lens |
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
8 Wall or ceiling mounting — The unit should not be mounted
on a wall or ceiling, unless specified in the Operating
Instructions.