Samson 42-36 E Mounting And Operating Instructions page 64

Servicing
Î Wear protective clothing, safety gloves
and eye protection.
WARNING
!
Risk of personal injury due to the regulator
tipping.
Î Observe the regulator's center of gravity.
Î Secure the regulator against tipping over
or turning.
WARNING
!
Risk of lifting equipment tipping over and
risk of damage to lifting accessories due to
exceeding the rated lifting capacity.
Î Only use approved lifting equipment and
accessories whose minimum lifting ca-
pacity is higher than the weight of the
valve (including actuator and packaging,
if applicable).
Î Refer to the 'Design and principle of op-
eration' section for the weights.
WARNING
!
Risk of burn injuries due to hot or cold
components and pipeline.
Regulator components and the pipeline may
become very hot or cold. Risk of burn inju-
ries.
Î Allow components and pipelines to cool
down or warm up to the ambient tem-
perature.
Î Wear protective clothing and safety
gloves.
9-2
NOTICE
!
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specified torques when tighten-
ing regulator components. Excessive tighten-
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Î Observe the specified tightening torques
(see 'Tightening torques' in Annex).
NOTICE
!
Risk of regulator damage due to the use of
unsuitable tools.
Î Only use tools approved by SAMSON
(see 'Tools' in Annex).
NOTICE
!
Risk of regulator damage due to the use of
unsuitable lubricants.
Î Only use lubricants approved by
SAMSON (see 'Lubricants' in Annex).
EB 3018 EN