Advertisement
c
Connection of antennas
@ Push the lever.
@ Insert the conductor.
@) Return the lever.
@
Never short-circuit the + and - speaker cords.
@
If the feft and right speakers are connected inversely or if
the speaker cords are connected
with reversed polarity,
the sound becomes unnatural with ambiguous acoustic
image positioning.
Be sure to connect the speakers and
speaker cords correctly.
Setting the SPEAKER IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
AorB
LESS THAN 8 >
Aore
AandB
8 > OR MORE
85 OR MORE
<a
=
SURROUND
ON
AorB&S
> OR MORE
@ When Surround speakers are not connected
According
to the impedance
of the speakers
used, set the
SPEAKER IMPEDANCE
SELECTOR on the rear panel as shown
in the table
@ During
speaker
system
connection
and
operation
of the
SPEAKER IMPEDANCE SELECTOR, set the POWER switch to
OFF,
@ When the IMPEANCE SELECTOR is in
¥) position, sound
is not output from the center and rear speakers.
@ When Surround speakers are connected
Usable speaker
Selector
Usable speaker
Selector
impedance
position
impedance
position
When speakers A and B are connected
.
The impedance of the front speakers
=a
A
and
B, center
speaker
and
rear
-< I
The impedance of both speakers
speakers should be 8 2 — 16 Q.
should be 8 2-162
-
When speakers A or B are connected
=P
When the impedance of the
L a
speakers is 8 Q- 162
—
i
When the impedance of the
speakers is 42-6
Q
When both of SPEAKERS A and 8 keys are ON, pressing
the PRO LOGIC key or 3 STEREO key switches the speak-
ers key setting to A ON alone. If the B key is pressed now,
the SPEAKERS
key setting will be switched
to B ON
alone.
FM DE-EMPHASIS/CHANNEL SPACE switch
{Except for some areas}
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel
is set to the correct setting that prevails in the area to which the
unit is shipped.
However,
if the FM DE-EMPHASIS/CHANNEL
SPACE setting is not matched to the area where the unit is to be
used; for instance, when you move from area 1 to area 2 or vice
versa, desired reception of AM/FM
broadcasts is not expected. In
this case, change the FM DE-EMPHASIS/CHANNEL SPACE setting
in accordance with the area corresponding to the table.
The FM
DE-EMPHASIS is switched over at the same time.
@ When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again during
pressing the TUNER key of the input selector, and turn the pow-
eron.
@ When activating the CHANNEL SPACE switch, the preset mem-
ory contents of the tuner and the set up memory contents of
the SURROUND function will be lost.
Area
CHANNEL
FM DE-
SPACE freq.
EMPHASIS
1| ULS.A., Canada, and}
FM
: 100 KHZ
75S
South American
AM
: 10 KHZ
countries,
2)
Other countries
FM
:50 KHZ
50us
AM :9 KHZ
DE-
EMPHASIS
CHANNEL
SPACE
AM
FM
50us i A oxHz © SOKHz
75us LI gioxHz
100KHz
Advertisement
