Advertisement
In case of difficulty
Remote control unit
Symptom
Cause
Remedy
Remote control operation is not possible.
oe
@ Batteries are exhausted,
@ The audio cords and the system
control
cords are not connected properly.
@ The remote control unit is too far away
from the main system, controlling angle is
too
large,
or there
is an
obstacle
in
between.
@ The
source
component
to be operated
does not contain the analog disk, tape(s)
or CD.
@ An attempt is made to play a tape which
is being recorded in the cassette deck.
@ Replace with new batteries.
@ Connect
properly
referring
to
"System
connections".
@ Operate
the
remote
control
unit within
the controllable range.
@ Pilace an analog disk, tapets) or CD in the
source component to be played.
@ Wait until the recording is completed.
Amplifier section
Symptom
Cause
Remedy
Sound is not output.
@ The speaker cords are disconnected.
@The
VOLUME
is set to the minimum
position.
@ The MUTING
key of the remote control
unit. is set to ON and the point indicator is
blinking.
@ Connect
them
properly
referring
to
"System connections'.
@ Adjust the volume to a proper level.
@ Press the MUTING key to OFF.
No sound comes out, and "PROTECT" is
shown on the display.
@ Speaker cords are short-circuited.
@Turn
the
power
off,
eliminate
the
short-circuiting,
then turn on
the power
again.
Sound
is not output from
one
of the
speakers,
@ The speaker cord is disconnected.
@The
BALANCE
control
extreme position.
is set
to
an
@ Connect it properly referring to "System
connections'.
@ Adjust the Left/Right balance.
Sound is not output from the Surround
tear
speaker
and/or
center
speaker,
or
their sound is very small.
@The
rear-speaker
cords
and/or
center
speaker cord are disconnected.
@ The
Surround
play mode
has not been
engaged.
@ The REAR LEVEL and/or CENTER LEVEL
controls are set to the minimum level.
@ The SPEAKER
IMPEDANCE
SELECTOR
on
the
rear
panel
is
set
to
the
SURROUND off side.
@ Connect
them
properly
"System connections'.
@ Set the Dolby Surround
or 3 STEREO
mode.
@ Adjust
the
REAR
LEVEL
and
CENTER
LEVEL controls.
@Set
the
SPEAKER
IMPENDANCE
SELECTOR to the SURROUND ON side.
referring
to
A hum
noise
is generated
when
the
PHONO input selector key is pressed.
@ The audio cord from the turntable is not
inserted securely into the PHONO jacks.
@ The turntable is not grounded.
@ Insert the audio cord plugs securely into
the PHONO jacks.
@ Connect the grounding wire to the GND
terminal on the rear panel.
28 xRr-veo30 (En)
Advertisement
