Advertisement
{-
System control operation
Connection
Using the system control cords provided with KENWOOD
system component
models, make connections as shown
below.
Turntable
|_ fe
fh
ae
ces
For a cassette deck to
To AC
outlet
be subject to system
control operation, it
must be connected to
oa
&
the TAPE 1 jacks.
r
Cassette deck
(J
layer
System control cord
CD pl
b 5
System control connection
x
Ht
hess
SYSTEM CONTROL terminals.
system functions wilt not noperate.
@ Be sure to insert the system control cord plugs fully into the
@ If the systern control cord and audio cords are not connected
properly, the automatic system governing remote control and
O
[=
Operation
By connecting this unit to KENWOOD
cassette deck CD player,
and turntable modeis equipped with system control jacks, the
foilowing integrated operation features become available.
1. Automatic play operation
a
When starting play with the turntable, cassette deck, or CD
player connected to the receiver, press the desired input se-
lector keys on the receiver. The turntable, cassette deck, or
CD player will autornaticlaly enter play mode.
In the same way, pressing the pLay key of turntable, cas-
sette deck, or CD piayer will automatically switch the input
selector on the receiver to the component on which the
Play key is pressed.
2. Synchro recording
To record the sound from the CD player or tumtable on to a
tape with the cassette deck, press the CD or PHONO of the
input selector keys and load a CD or record.
Set the cas-
sette
deck
to
rec
pause
mode,
then
press
the
PLAY
(START) key of theCD player or tumtable.
The cassette
deck will start recording automatically, synchronized with
the CD player or turntable starting play.
3. Remote control
The remote control unit provided with this unit, to which a
KENWOOD system turntable, cassette deck, or CD player is
connected, is equipped with reiated control keys. The relat-
ed components can be controlled used these keys.
KR-va0g0 (En) 9
y
Advertisement
