Operation; Operating Controls - Kenwood TS-140S Instruction Manual

4. OPERATION
4-1. OPERATING CONTROLS
4-1-1. Front Panel
® ®@ ®@ © ®©©
Note:
All segments on the Display Panel and Indicators are
shown on for this explanation.
® ® © OO®Q ®
{=
4 ot | tge uss M.CH SCAN AVFOB SPLIT 3
OFF SAMI FULL
OFF SqMLFULL
exh fo EF wOhGRBRAEEE -alp GD
ON QOFF 'ON AIR CS M.SCA cS FLOCK 1MHz PWR
— a vay
2 EEKENWOOD =nuitiavoch Ts-1405- C= t—_19)
HONES
a oe
MIC
6 MEMORY M.CH/YFO CH MODE MIN Max |
OTN
O
RF GAIN il
MIN MAX
(With the TS-680S)
> AGC ae al
@ POWER switch Se
Press to turn the power ON or OFF.
@
@ Program keys
F.LOCK : The selected dial frequency and mode are
locked.
MeV: Used to transfer a frequency from
memory to the VFO.
M.IN : Used to enter data into a memory channel.
VFO/M : Used to switch between memory or VFO
operations.
SCAN _: Pressing during VFO operation will initiate
program scan, and pressing during
memory operation will initiate memory
scan.
CLEAR : Used when reentering memory channel
data, erasing a memory channel, clearing
scan, or when specifying the channels
that will be skipped during scan opera-
tions.
@ Meter
During receive the meter is used as an S-meter. Dur-
ing transmit the function of the meter is controlled
by the Meter switch @ , and provides either ALC
level, or PWR (power) readings.
@ M.CH/VFO CH (Memory channel/VFO
channel) control
This control is used to change the frequency in 10
kHz steps during VFO operations. This is convenient
when large changes in the operating frequency are
@ Q BW @d wd
required and for FM operations.
This control is also used to select the desired
memory channel during Memory Channel Operation.
© Indicators
ON AIR : Lights during transmit.
M.SCR_ : Lights when the M.IN key is pressed.
When the memory scroll function is active
you can review the contents of the
memory channels without a loss of the in-
coming receive frequency.
F.LOCK : Lights when the F.LOCK key is ON.
1 MHz _: Lights when the 1 MHz step switch is ON.
© MODE keys
These keys are used to select the desired mode of
operation. In CW mode the CW/N key is also used to
select the desired filter bandwidth. When a MODE
key is pressed the first character of that mode will be
sounded in Morse code thru the internal speaker.
This announcement can be inhibited by following the
instructions in Section 4-2-8.
LSB/USB key : Press the LSB/USB key to alternate
between LSB and USB.
CW/N key : Press the CW/N key to alternate be-
tween CW (SSB filter) and N (nar-
row).
Note:
There will be no audio from the
speaker in the CW narrow position if
no optional CW filter is installed.
AM/FM key : Press the AM/FM key to alternate
between AM and FM.