Kenwood TS-140S Instruction Manual page 24

4-4-5. Memory Channel Recall
Fixed channel type recall is possible when using the
VFO/M key to recall Memory Channel information.
The stored frequency cannot be changed.
The following procedure shows how to recall a chan-
nel.
1. During VFO operation,
press the VFO/M key to
initiate Memory Channel operation. This causes
the Memory Channel to return to the status
(mode, and frequency) prior to the Memory Chan-
nel operation.
Example:
When 14.175 MHz is stored in Memory Channel
03.
. Select a Memory Channel by using the M.CH/VFO
CH control, or SPLIT key.
Example:
When Memory Channel 08
selected.
(28.800 MHz) is
3.
uss. M.CH
eecébhaedad
If you press the VFO/M key again, the original
VFO operating information will be restored.
4-4-6. Checking highest and lowest operating fre-
quencies
The highest and lowest operating frequencies stored
in Channels 20 to 30 can be checked by the follow-
ing method.
1.
2
a:
. Press the BAND DOWN switch.
5.
During VFO operation, press the VFO/M key to in-
itiate Memory Channel operation.
. Select the desired Memory Channel by using the
M. CH/VFO CH control.
Press the BAND UP switch.
To return to normal VFO operations press the
VFO/M key.
4-4-7. Clearing a Memory Channel
To erase a specific Memory Channel:
i
2:
Press and hold the CLEAR key for approximately
1.5 seconds.
Transfer data from an empty Memory Channel to
the Memory Channel you wish to clear. (Please
refer to Section 4-4-10 for additional
information.)
4-4-8. Memory Channel Scroll
The following procedure provides a method to check
a Memory Channel Frequency without changing or
24
loosing the current receive frequency.
1
2.
4-4-9. Transferring Memory
Information to the
VFO.
1:
usp M.CH
7 f ES ab fy Ghd.
epee Y of i GG
2. Select the desired Memory Channel by using the
M.CH/VFO CH control, or SPLIT key.
Example:
Memory Channel 06 containing 21.225 MHz is
selected.
uss. M.CH
- J'r77 7
(eee RoW
3. Press the M m V key. The contents of the Memory
Channel will be transferred to the VFO and opera-
tion changes to the VFO mode.
If you transfer the contents of one of the Split Fre-
quency Memory Channels to the VFO, the
transceiver will automatically select the SPLIT
mode.
Notes:
1. When the M » V key is pressed, the contents
of the VFO are cleared but the contents of the
Memory Channel will not be cleared.
2.If nothing is stored in the selected Memory
Channel, only the channel number is displayed;
no transfer is carried out.