Kenwood TS-140S Instruction Manual page 26

4-5. SCAN
Both Memory Scan and Program Scan are possible.
4-5-1. Memory Scan
During memory channel operation, pressing the
SCAN key will cause the radio to scan the memory
channels repeatedly, skipping the channels that have
on data stored.
To cancel scan press the CLEAR key. A ''Check
Memory"' will be emitted from the speaker in Morse
code if you press the SCAN key and the memory
channels are vacant. Please refer to Section 4-2-8.
4-5-2. Programmable Band-scan
If you press the SCAN key during VFO operation
scan will begin at the current frequency and proceed
upwards. ''P'' will appear in the display to signify
Program
Scan. To cancel this scan
operation press
the CLEAR
key. If channel
30 is empty the lower
limit of 50.0
kHz and an upper limit of 34.999.9
MHz (59.999.9 MHz with the TS-680S) will
automatically be stored when the SCAN key is
depressed.
a. If scan is initiated within the limits specified in
Memory Channel 30 scan will proceed thru that
range.
Lowest (Highest) Highest (Lowest)
operating SCAN key:ON Operating
frequency 1 frequency
ie T— {
I (esi ecraneaadoa
[eee eo See ee
[ae SE ae ee =
Vi. Slo
a wl
|
b. If scan is initiated outside the limits specified in
Memory Channel 30 scan will proceed outside of
the programmed limits.
4-5-3. Scan Speed
The scanning speed is adjustable from the front
panel by using the RIT control during SCAN opera-
tions. Clockwise rotation increases the scan speed
and counterclockwise rotation decreases the scan
speed. This speed adjustment is effective in both
VFO and M.CH scan modes. Once set the scan
26
4-5-4. Scan Hold
4-5-5. Memory Channel Lockout
3. Press the CLEAR key.
usp M.CH
5 'uo orne
OF FY PT SoG
usp) M.CH
f 1 7
cy, the 1 S.G
indicator flashes
5. To cancel the lockout, select the desired channel
and then press the CLEAR key. The decimal point
will go out indicating that the channel will again
be scanned.
use.) M.CH
fuotn 7
cd A ot = u
Notes: