Table of Contents
Advertisement
Iti is recommended to remove the top
oven door (see, disassemble oven
door on page 35), to provide an
ergonomic disassemble of the oven
burner.
1- Unscrew 3 screws (3) to remove
oven burner (2) and oven burner holder
(7).
2- Gently pull up burner and holder in
"A" direction- be careful with gas
connection tube and thermocouple.
3- Push the clips (8) in "B" direction to
disassemble oven burner (2) and its
holder(7).
4- Unscrew the injector (6) and replace
it with appropriate injector, see injector
table, on page 7.
5- Conduct the leakage control after
replacing the injector.
6- Assemble the oven burner (2) to its
holder (7) by pushing the burner on the
clips (8) in "B" direction.
7- Mount the oven burner (2) and
holder (7) as a group to the cavity by
screwing 3 screws (3).
Reduced flow adjustment for the
gas oven
Reduced flow rate adjustment is
extremely important for the
appropriate functioning of the oven. In
order to provide maximum security to
the user these operations have to be
done with care.
1. Ignite the burner that is to be
adjusted and turn the knob to the
high flame position.
2. Close the oven door and wait for 10
to 15 minutes until the oven
becomes ready for adjustment.
3. After 15 minutes, adjust the oven to
the lowest flame position.
4. Take out the knob.
5. Set the flame length to 2 to 3 mm
by means of the screw 2 on the
oven tap. Turning in clockwise
direction reduces the flame, turning
counter-clockwise increases the
flame.
If the temperature of the oven
increases excessively, turn off
the oven and call the authorised
service agent to have oven
thermostat repaired.
19 | EN
Advertisement
Table of Contents
