Station Memory (Radio Broadcas1); (Station Name Function); Rds Selection And Display - Pioneer XC-L7 Operating Instructions Manual

=—4
YS @_|
aoje@)
pie
VOLUME
PeOWeER
MOTE GONTIOL UCT
Each time the J is buttons are pressed, the mode
RDS SELECTION AND DISPLAY changes in the sequence shown.
1. Use the FM/AM/STATION button to seiect
"FM."
= =
o—— Be OG) —_4
(ed
STATION MEMORY
STATION NAME
(Can be selected
during STATION
mode).
FM/AM/STATION
2. Press the MENU button. When Ee]
CJ)
When b=]
amen = is pressed is pressed
i | 2 FM MONO
3. Use the Ed, = buttons to select one of the RDS (RT)
following: "RT," "PS," "PTY," or "PTY
SEARCH." RDS (PS)
RDS (PTY)
RDS (PTY SEARCH)
RT mode
PS mode 4. Press the SET button.
NOTES:
PTY mode @ The RDS indicator will light in the RDS mode.
@ The mode is automatically indicated in the bottom
of the display.
ry SAR @ /fno RDS signal can be received, the "NO DATA"
message will be displayed.
@ if there is noise during the RT scroll display when
in the RT mode, some characters may temporarily
be incorrectly displayed.
automatically to display the selected data @ in the RT mode, when no FT data is transmitted,
' "NO RADIO TEXT DATA" is displayed.
@ During RDS broadcast reception in the PTY mode,
"NO TYPE" data may be displayed. In this case, it
will automatically switch to PS mode after a few
seconds.
@® Depending on the broadcast station, numeraus pro-
gram station names (PS) may be transmitted in
succession. In this case, when you switch to the AT
mode, only some of the PS data will be displayed,
so switch to the PS mode.
En <ARB7126> 29)
When "RT," "PS," or "PTY" is selected, the SET but-
ton does not need to be pressed in step 4; about 3
seconds after the selection, the display will change