Table of Contents
Advertisement
10.1
Power board fuse replacement
Proceed as indicated below (reserved for qualified technical
personnel only):
• Disconnect the power to the equipment.
• Remove the top cover of the equipment and then the power
board cover.
• Remove the fuse cap, then the fuse, using a suitable screw-
driver.
• Install a new IEC-60127-2/II certified time-delay 5 A fuse
(T5AL250V), then refit the protective cap.
• Reassemble all the plastics and make sure the equipment is
correctly installed before powering it.
10.2
Heating element safety thermostat reset
This equipment has a manual-reset safety thermostat connect-
ed in series with the heating element immersed in water, which
interrupts the power supply in case of overtemperature inside
the tank.
If necessary, proceed as follows to reset the thermostat (re-
served for qualified technical personnel):
• Unplug the product.
• Remove any air ducts.
• Remove the top cover by first undoing the locking screws
(fig. 36).
• Remove the front panel and manually reset the tripped safe-
ty thermostat (fig. 37). In case of intervention, the central pin
of the thermostat comes out by about 2 mm.
• Refit the previously removed top cover.
Page 34
fig. 35
fig. 36- Top cover removal
fig. 37- Front panel removal
User, Installations and Maintenance Manual
Advertisement
Table of Contents
Troubleshooting
