Mitsubishi Electric 800 Series Instruction Manual page 31

 Motor used and switch setting
Motor
Mitsubishi Electric standard motor with
encoder
Mitsubishi Electric high-efficiency motor with
encoder
Mitsubishi Electric constant-torque motor with
encoder
Mitsubishi Electric high-performance energy-
saving motor with encoder
Vector control dedicated motor
Other manufacturer's motor with encoder
*1 Set according to the motor (encoder) to be used.
*2 Prepare an encoder's power supply (5 V/12 V/15 V) according to the encoder to be used. Use terminal PG24 for the 24 V encoder's
power supply.
*3 When the encoder output is the differential line driver type, only 5 V can be input.
NOTE
• When power is not supplied to the control circuit of the inverter, also turn OFF the power supply to the encoder. Otherwise,
the plug-in option may be damaged.
30
WIRING
Encoder specification
selection switch (SW3)
SF-JR Differential
SF-HR Differential
*1
Others
SF-JRCA Differential
SF-HRCA Differential
*1
Others
SF-PR-SC Complementary
SF-V5RU Complementary
SF-THY Complementary
*1
Terminating resistor
selection switch (SW1)
ON 5 V
ON 5 V
*1 *1*3
ON 5 V
ON 5 V
*1 *1*3
OFF 12 to 24 V
OFF 12 to 24 V
OFF 12 to 24 V
*1 *1*3
Power supply
*2
specification