Names Of Camera Parts; Installing The Camera - Toshiba IK-WB15A User Manual

Names of Camera Parts

Front
Sun visor (→ page 19)
(Accessory)
Reset button
Side
・Reset the settings to the defaults by using a
thin, pointed object to press the button for at
least 5 seconds. (The AC adapter must be
connected)
(The log information is not returned to the
default state. To return the log information to
the default state, delete the log information in
the settings screen.)
・You can turn video output on/off by pressing
the button for less than one second. When video
output is on, images and sound cannot be
delivered to the network and images cannot be
recorded. Use this feature only when, for
example, checking the angle of view during
installation.
SD memory card slot (→pages 12
and 49)
Microphone input/Audio output jack
Rear cover fixing
screw (M3) ・Jack for connecting an external microphone.
Use 3.5 φ monaural-plug microphone.
(→ page 18)
・Sound input from a microphone.
・Sound output to speaker Amp.
Rear
ALARM IN
Alarm input terminal
ALARM OUT
Alarm output terminal
GND
16
Lens
(Focal range: 1 m to
infinity)
Lens cover
(Transparent sphere)
Bottom
Screw hole for attaching
a tripod or other stand
DC IN 12V
Power input terminal (→ page 20)
・Be sure to use the AC adapter included with the
network camera.
10/100 ETHERNET
Ethernet jack

Installing the Camera

Some provided parts are required for installing the camera.
● Installing the camera indoors
･ Rear cover
● Installing the camera outdoors
･ Rear cover
･ Sun visor
･ Wall Bracket
■ Indoor Installation
1
Install the rear cover to the wall
･ Install each of the four corners to the wall using four wood screws.
Important
Securely tighten the screws during installation to ensure not to become
●
loosen.
2
Insert the AC adapter cable and the LAN cable
through the cable conduit
･ Insert both cables from below.
17