Table of Contents
Advertisement
Printer
Refer also to the
and to the troubleshooting and other relevant sections in your printer and
software documentation.
Problem
Printer does not turn on. Check that the printer is connected to an electric
Computer/printer do not
communicate
Printer error
TV output signal
Refer also to your TV set's documentation.
Problem
Display on TV is poor
No display
If you turn the computer off in Standby mode while the display is on TV, the
computer will select either the internal LCD or an external computer CRT
as the display device.
TECRA M4
Parallel printer
sections in Chapter 8,
Procedure
outlet. Make sure the outlet is supplying power by
plugging in an appliance.
Make sure the printer is turned on and is online
(ready to use).
Inspect the cable connecting the printer to the
computer for damage. Make sure it is securely
connected.
A parallel printer connects to the parallel port.
Make sure the port is configured correctly. Refer
to Chapter 7,
Make sure your software is configured to
recognize the printer. Check your printer and
software documentation.
Check your printer documentation.
If problems persist, contact your dealer.
Procedure
Make sure the TV type is correct for your area:
NTSC (US, JAPAN), PAL (Europe).
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
If problems persist, contact your dealer.
Optional
HW
Setup.
The
Keyboard.
Troubleshooting
Devices,
9-20
Advertisement
Table of Contents
