Disconnecting - Toshiba Tecra M4-103 User Manual

■
Connection to any communication line other than an analog phone line
could cause a PC system failure.
■
■
■
■
■
Never operate your PC on AC power during a thunderstorm. If you see
lightning or hear thunder, immediately turn off the PC. An electric surge
caused by the storm, may result in a system failure, loss of data or
hardware damage.
■
To reduce the risk of fire, use only No.26 AWG or larger modular cable.
1. Plug one end of the modular cable into the computer's modem jack.
2. Plug the other end of the modular cable into a telephone jack.
Do not pull on the cable or move the computer while the cable is
connected.
If you use a storage device such as an optical drive or HDD connected to a
16-bit PC card, you might experience the following modem problems:
■
Modem speed is slow or communication is interrupted.
■
Skips may occur in sound.

Disconnecting

To disconnect the internal modular cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer's modem jack in the same
manner.
TECRA M4
Connect the built-in modem only to ordinary analog phone lines.
Never connect the built-in modem to a digital line (ISDN).
Never connect the built-in modem to the digital connector on a
public telephone or to a digital private branch exchange (PBX).
Never connect the built-in modem to a key telephone system for
residences or offices.
Connecting the internal modem
Modem jack
Operating Basics
Telephone jack
Modular cable
4-36