Enabling/Disabling Automatic Brightness Adjustment; Setting Indicator; Enabling/Disabling Auto Power-Off - Eizo RadiForce MS231WT User Manual

4-3. Enabling/Disabling Automatic Brightness
Adjustment
The sensor on the front side of the monitor detects the environmental brightness to adjust the screen brightness
automatically and comfortably by using the Auto EcoView function.
Attention
• The Auto EcoView function cannot be used in the DICOM mode.
• Be careful not to block the sensor on the lower side of the monitor when using the Auto EcoView function.
Procedure
1. Press .
The "EcoView" menu appears.
2. Choose "Auto EcoView" with
3. Select "On" or "Off" with
4. Press
Note
• For this reason, as <Brightness> in the Adjustment menu is changed, the auto adjustment range is also changed.

4-4. Setting Indicator

By using the EcoView Index function, the indicator that shows the level of power saving appears at the time of
turning on the monitor, adjusting the brightness or switching the mode. The power saving ratio comes to high
as the indicator level meter lights towards right.
Procedure
1. Press .
The "EcoView" menu appears.
2. Choose "EcoView Index" with
3. Select "On" or "Off" with
4. Press

4-5. Enabling/Disabling Auto Power-OFF

This function allows you to specify whether to turn on/off the monitor automatically after a specified time has
elapsed in the power saving mode.
Adjustable range
Disable, Enable (0, 1, 2, 3, 5, 10, 15, 20, 25, 30, 45 min, 1-5 h)
Procedure
1. Choose <PowerManager> from the Adjustment menu, and press
2. Choose <Off Timer> from the <PowerManager> menu, and press
The <Off Timer> menu appears.
3. Select "Enable" or "Disable" with
If "Enable" is selected, set a monitor Off time with
4. Press
or . (Alternatively, you can use
or .
to exit the adjustment.
or . (Alternatively, you can use
or .
to exit the adjustment.
or .
to exit the adjustment.
to select it.)
to select it.)
.
.
or .
Chapter4PowerSavingFunctions
33