Table of Contents
Advertisement
9. Post-repair Check
If you have replaced or repaired the component, check it against the
following and perform a test run to identify any fault:
1) Check the insulation resistance.
After you remove the power plug from the outlet, check the insulation
resistance between the plug and body ground wire to confirm whether
the resistance is 2 ㏁ or higher with a 500 V DC tester.
2) Handle the internal wiring.
The electric wiring for distribution should not come into contact with any
moving part or sharp part on the outside check if the terminals are fixed
completely.
3) Check for water leak
Check the drainage pump and piping for water leak.
54
Advertisement
Table of Contents
