LG FH6G1BAPK2 Service Manual page 15

Check the horizontality with a level (Gage).
Step 1
If washing machine legs are loose or not fully attached, then tighten with the spanner wrench.
Using the level, level the washing machine from front to back and side to side.
A level
Step 2
Use the spanner wrench to adjust legs until level and try the Diagonal test.
Diagonal test
Higher
Loosen Tighten
Adjustable feet
Lower the foot until there is no gap between floor and foot.
And only use adjustment rubber when the gap is more than 10mm.
Rubber Cup
Step 3
Perform a Rinse and Spin with some clothing in the machine.
To do this, put 2~3kg of clothing in the unit, turn on the unit, select the Rinse+Spin
and then start. When the unit reaches the spin cycle, check vibrations.
If the unit vibrates, adjust the leveling foot slightly until the vibration subside. (Repeat step 2)
Step 4
Tighten the lock nut up to lock the positioned leg.
How to perform a diagonal test:
Place your right hand on the back, right corner and your left hand on the front,
left corner of the unit, then attempt to rock the unit from corner to corner.
Then, move your right hand to the front, right corner and your left hand to the
back, left corner and attempt to rock the unit from corner to corner.
If the unit is level, it will not rock. However, if the unit is not level, it will rock.
If the unit rocks, it will be necessary to adjust the leveling feet of the unit.
Adjust the foot on the front right corner.
Lock nut
Lower
Adjustable bolt
Adjustable feet
4620ER4002A
(Black)
for Tile floors
15
Lower
Tighten
Adjustable feet
Gap
No Gap
Floor
Tighen the lock nut
10mm
Floor
4620ER4002B
(Gray)
for Wooden floors
No Gap
Floor