Push Buttons; Display - Panasonic EBL512 User Manual

2.2. PUSH BUTTONS

See reference picture on page 4.
15
DEL
16
ESC
17
Key pad
18
Enter
19
Left / right keys
20
Up / down keys
21
Alarms queued
22 - 25
Soft keys
26
Reset
27
Silence alarm devices
28
Silence buzzer

2.3. DISPLAY

See reference picture on page 4.
29
The door is open in any c.i.e. (not valid for 5055) in the system.
30
Loss of mains in any c.i.e. or external power supply unit in the system. The unit is currently power supplied via batteries.
Service signal. The week average sensor value is over the service level, or detector is outdated, for one or more analog smoke detectors in the system.
Menu H4/U5 (Symbol flashing): The system is in service mode:
• A COM loop is disconnected
31
• A COM loop is in service mode
• A Zone line input is disconnected
• Check loop, Autogenerate loop or Auto-addressing function etc. is in progress
32
The c.i.e. is set into "Sensitive fault detection mode" via menu H5/A2.
33
One or more "Technical warnings" are generated in the system.
34
The functions of the soft keys will vary depending on the situation, convention and language.
35
"Silenced Alarm devices" is indicated by this symbol.
Used to clear / delete all visible entry fields.
Used to stop input of data or to step upwards in the menu system.
Numeric key pad for the digits 0-9.
Used to accept / select a menu or input of data. Also used to acknowledge fault signal and service signal.
Used to move the cursor in a menu.
Used to scroll between the menus.
Used when LEDs "Alarms queued" are lit. Scroll through the queued alarm points or zone addresses.
NOTE! To scroll/browse through the queued zones, use the soft key "Next zone" (23).
The function is shown in the display above the soft key. The function of a soft key may vary. If nothing is
shown above the key in the display, the key has no function for the moment.
Used to reset: Fire alarms, co-incidence alarms.
NOTE! Has to be pressed for > 0.5 sec.
Used to silence alarm devices / sounders. If "silence alarm devices" is activated, it is indicated by a
symbol in the display, see (35).
Used to silence the buzzer in the c.i.e. when it is sounding.
6