Led Indicators And Push Buttons - Panasonic EBL512 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: -
5
LED indicators on the Fire Brigade Panel (FBP)
LED indicator
L1 Fire (5 red)
L2 Alarms queued (2 red)
L3 Extinguishing (red)
L4 Ventilation (yellow)
L5 Fire brigade tx (red)
L6 Operation (green)
Operating Instructions Fire alarm system EBL512, V2.7.x

LED indicators and push buttons

LEDs and push buttons can vary according to type and configuration
(convention / country / language).
See also Figure 2, page 16.
Indicating
Fire alarms (also Pre-warning, Heavy smoke/heat alarm,
Alert Annunciation alarm, Quiet alarm & Key cabinet alarm)
More than one unit / zone have generated fire alarm. Use
push button "Alarms queued" (P1) to scroll.
Output(s) for extinguishing equipment activated ("Activated
9
extinguishing").
Output(s) for fire/smoke ventilation equipment activated
("Activated fire ventilation").
Output for fire brigade tx (routing equipment) and/or
corresponding programmable output(s) (i.e. type 4 = routing
equipment) activated.
Test of routing equipment in progress (see menu H1).
The c.i.e. is powered via the rectifier or the battery.
(FBP push buttons on next page)
8
See chapter "Alarm types", page 39. In the New Zealand convention also
"Acknowledged alarm" (ACK).
9
L3, L4 and L5 can as an alternative be programmed to indicate when a
programmable input is activated, i.e. input trigger condition "Activated
Extinguishing", "Activated fire ventilation" and "Activated routing
equipment" respectively (e.g. L5 can be turned on when a programmable
input is activated by an activated routing equipment output).
17
9
9
8