Timer_On_System_Before_Pump; Timer_Flow_Detection_Pump - Daikin Comfort Flex CLIV Series Installation, Operation And Maintenance Manual

As you can see each menu
has a number at the top of the
screen, this number indicates
the position of the menu that you
want to access, in this case the
parameters that you want to access for times and stops and alarm
reset is number 6.
After having pressed the dial as mentioned in the previous step
and as shown below, you can access the Modbus parameters
menu, inside this menu it is necessary to turn the dial and select
the Dapoints folder, once the datapoints folder is selected, it is
necessary to press the dial to access it.
Once the dial is pressed as mentioned in the previous step, a
menu will be accessed again and the same step of turning the
dial and selecting FB1 and pressing the dial will be repeated to
access the root.
iom-cliv-eng
Once the previous step has been performed, a menu will be
accessed again and the same step of turning the dial to the right
and selecting PGM1 will be repeated and pressing the dial to
access the root.
ACCESSING CLIV EQUIPMENT CONTROL AND
OPERATION PARAMETERS.
Los siguientes parámetros tienen la finalidad de poder modificar
el comportamiento del equipo dependiendo de la necesidad a la
cual se tenga que ajustar en sitio estos parámetros ya vienen pre
ajustados de fábrica y sólo deben ser modificados por personal
calificado para poder realizar la modificación de este parámetro
consultar la sección de modificación de parámetros en este
manual.
Parameter number 1:

Timer_On_System_Before_Pump:

This parameter is intended to modify the system startup time.
Parameter number 2:

Timer_Flow_Detection_Pump:

The purpose of this parameter is to modify the water flow detection
time when the system is at start-up.
48
Controller Use
www.comfort-flex.com