Table of Contents
Advertisement
4. Set the Uprights (83) on the Base (74). Make
sure that the hole with the Upright Wire (75)
is on the right side.
Attach the right Upright (83) with two of the
3/8" x 3 1/4" Screws (18) and two of the 3/8" x
2 3/4" Screws (22) that you just removed and
four 3/8" Star Washers (3); do not fully tighten
the Screws yet. Make sure that the Base
Wire (52) is not pinched.
Attach the left Upright (not shown) as
described above. Note: There is not a wire on
the left side.
Then, fully tighten the 3/8" x 3 1/4" Screws
(18) and the 3/8" x 2 3/4" Screws (22).
5. Connect the Base Wire (52) to the Upright
Wire (75). IMPORTANT: The wire connectors
should slide together easily and snap into
place with an audible click. If they do not,
turn one connector and try again. You must
connect the wires properly for your incline
trainer to function properly.
Then, remove the tie (A) from the Base Wire
(52), and insert the connectors into the hole (B)
in the right Upright (83).
4
83
3
5
83
A
9
18
3
3
75
3
52
74
B
75
52
52
22
75
Advertisement
Table of Contents
