NordicTrack NTL29221-INT.1 User Manual page 26

SYMPTOM: The incline trainer will not connect to
the wireless network
a. Make sure that the wireless settings on the console
are correct (see page 21).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to my.iFIT.com
SYMPTOM: The console does not stay in place
a. If the console will not stay in the desired position
because it is too loose, use a hex key to slightly
tighten the console in the indicated location on both
sides (only one side is shown).
a
SYMPTOM: The displays of the console do not
function properly
a. If the console does not display speed and distance
properly, remove the key from the console and
UNPLUG THE POWER CORD. Next, remove the
indicated #8 x 3/4" Screw (5), and lift off the Left
Foot Rail Cover (44).
a
Next, locate the Reed Switch (113) and the Magnet
(112) on the left side of the Pulley (42). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. The gap between the Magnet and the
Reed Switch must be about 1/8 in. (3 mm). If
necessary, loosen the #8 x 3/4" Clip Screw (111),
move the Reed Switch slightly, and then retighten
the Clip Screw. Then, reattach the Left Foot Rail
Cover (44), and run the incline trainer for a few
minutes to check for a correct speed reading.
Top View
111
113
1/8 in.
26
44
5
112
42